Configuration settings for the WiFi Sensors
The Mote ID is used for communication with the Sensor and can only be set by R&D Scientific personnel.
The Sensor Timeout value (minutes) of this sensor sets how long after communication has been lost with the Sensor before a WiFi Sensor Alarm is triggered.
Type: |
Numeric |
Range: |
2 to 240 |
Format: |
## |
The Hardware Type of the Sensor. Can only be set by R&D Scientific personnel.
Options include:
CONT-1022 |
Two Port Dry Contact Switch Sensor |
CURR-1022 |
Two Port 4-20mA Current Port Sensor |
TEHU-1121 |
Two Port Temperature & Humidty Combo Sensor |
TEMP-1122 |
Two Port RTD Temperature Sensor |
TEMP-1124 |
Four Port RTD Temperature Sensor |
VOLT-1022 |
Two Port 0-10 Volt Sensor |
Sensor Active checkbox used to enable or disable all of the data acquisition functionality for this Sensor.
Checked: |
Data Acquisition Enabled for this Sensor |
Cleared: |
Data Acquisition Disabled for this Sensor |
Indicates the WiFi Sensor's Signal Strength.
Indicates the Battery's Voltage Level. A WiFi Battery Alert will sound indicating that the Battery should be replaced when the Level is at or below 2.75 Volts.
Indicates the last time the WiFi Sensor Transmitted Data.
The Alarm Message text box allows you to append an additional custom Alarm Message to Phone, Email, and Text Message Alarm Notifications for this WiFi Sensor.
Type: |
Alphanumeric |
Max Length: |
256 Characters |
The “Channel Mapping” section contains a “Select Channel” field and fields for each of the up to four (4) Sensor Ports. In general, the “Sensor Port” is assigned during initial installation and set up. The fields numbered “Port 1” through “Port 4” correspond to the Port Channels provided for a given sensor. Certain Sensors only have two (2) available Ports, in which case Port 3 and Port 4 will not be available for Channel Mapping.
Select a Channel to Map to the desired Sensor Port.
Select: |
Click to Select 1 Channel |
Click the "Map" button to Map the Selected Channel to Sensor Port 1.
Click the "Map" button to Map the Selected Channel to Sensor Port 2.
Click the "Map" button to Map the Selected Channel to Sensor Port 3.
Click the "Map" button to Map the Selected Channel to Sensor Port 4.
Previous |
Selects the Previous WiFi Sensor by Mote ID |
Edit |
Places the form into Update mode for Updating the Sensor |
New |
Places the form into Insert mode for Adding a new Sensor |
Displays a Printable Report for the selected WiFi Sensor |
|
Print All |
Displays a Printable Report for all of the WiFi Sensors |
Insert |
Insert Mode - Validates the page and Adds the Sensor if there are no errors |
Update |
Update Mode - Validates the page and Updates the Sensor if there are no errors |
Cancel |
Update / Insert Mode - Cancels the Update or Insert and places the page in View mode |
Map |
Update / Insert Mode - Maps the Selected Channel in the Select Channel field to the corresponding Sensor Port. Select the Channel "Unassigned" to leave the Sensor Port unmapped to a channel. |
Next |
Selects the Next WiFi Sensor by Mote ID |