The Channel Calibration page is used to Calibrate the sensor to the Datatron System.
The Channel Calibration page displays four boxes of values that are used to display the initial settings and the results of the Channel Calibration.
Voltage |
The real time voltage reading of the Channel in Volts |
Current |
The real time voltage reading of the Channel in mA |
Value |
The real time calculated value of the Channel in the corresponding Engineering Unit (i.e., C, F, %RH, %CO2, Volts, etc.) |
Note: |
These fields will be updated whenever the value of the sensor changes. This can be anywhere from a few seconds to a minute or more depending upon the type of sensor used for this channel. |
Zero |
The Initial Zero value of the sensor |
Scale |
The Initial Scale value of the sensor |
Offset |
The Initial Offset value of the sensor |
Note: |
These fields will be updated once the Calibration has been saved. |
Zero mA |
The mA Zero Value recorded during the Calibration |
Scale mA |
The mA Scale Value recorded during the Calibration |
Offset mA |
The mA Offset Value recorded during the Calibration |
Note: |
These fields will be updated once the Calibration or Mid Point procedure has been performed |
Zero |
The New Zero Value calculated after the Calibration or Mid Point procedure has been completed |
Scale |
The New Scale Value calculated after the Calibration or Mid Point procedure has been completed |
Offset |
The New Offset Value calculated after the Calibration or Mid Point procedure has been completed |
Note: |
These fields will be updated once the Calibration or Mid Point procedure has been performed. The Calibration must be Saved in order for these New Values to take effect. |
Previous |
Selects the Previous Channel by Channel Number |
Calibrate |
Opens the Calibration Input Window |
Mid Point |
Opens the Mid Point Input Window |
Save |
Validates the Calibration and Saves the changes if the Percent Change is less than or equal to 5%. The Save button will only function after the Calibrate or Mid Point procedure has been completed. |
Redo |
Clears all user inputted values |
Opens a printable Calibration Report. The Print button is only available after the Calibration has been saved. |
|
Cal Due Rpt |
Opens a printable Calibration Due Report with Due Date 1 year from the last Full Channel Calibration |
Next |
Selects the Next Channel by Channel Number |